Difference between revisions of "Camger 1-175 Polyglase Environmental Coating"

Jump to: navigation, search
(Personal Risks)
Line 18: Line 18:
==Personal Risks==
==Personal Risks==
* Not classified as hazardous under OSHA Haz-Com Standard (29 CFR 1910.1200), GHS
* Not classified as hazardous under OSHA Haz-Com Standard (29 CFR 1910.1200), GHS
* Total Boat (Camger Rust Primer): [http://www.totalboat.com/wp-content/uploads/2016/06/TotalBoat-Rust-Primer-SDS-2016.pdf SDS]
* For additional information, contact the company directly (or check back)
==Collection Risks==
==Collection Risks==

Revision as of 11:00, 1 December 2020


[Camger Coating Systems Inc.] A protective coating formulated with an aliphatic urethane and poly(propylene glycol). Camger 1-175 is designed to provide a barrier coating to minimize off-gassing. The preparation does not contain any solvents and the dried coating is resistant to abrasion, chemicals and hydrolysis.

Camger was originally made in two different formulations: Polyglase 1-175 and 1-146. 1-175 was the formulation that was originally developed and tested for conservation use, but 1-146 was very similar in formulation and cost. For a period the company kept 1-146 but discontinued the 1-175, then later restarted production of 1-175 by repurposing Sancure 878. Camger 1-175 has shown excellent adhesion properties to a wide variety of substrates such as, solid woods, particleboard, Medite II.

Synonyms and Related Terms

Polyglase I-175; Camger I-146

Similar products: Sancure 878


  • Coating - Clear Gloss Waterborne Finish
  • Sealant for wood products used in interior of exhibition cases
  • Gluing seams and as edge sealant for case materials (Field Museum)

Personal Risks

  • Not classified as hazardous under OSHA Haz-Com Standard (29 CFR 1910.1200), GHS

Collection Risks

Environmental Risks

Environmental precautions: No special measures required. Smaller quantities can be disposed of with household waste.

Physical and Chemical Properties

  • pH-value at 25 °C (77 °F): 7 - 8
  • Melting point/Melting range: Undetermined.
  • Boiling point/Boiling range: 100 °C (212 °F)
  • Flash point: >201 °C (>393.8 °F)
  • Vapor pressure at 20 °C (68 °F): 23 hPa (17.3 mm Hg)
  • Density at 20 °C (68 °F): 1.026 g/cm³ (8.56197 lbs/gal)
  • Solubility in / Miscibility with Water: Not miscible or difficult to mix.
  • VOC content: 1.6 g/l / 0.01 lb/gl

Working Properties

Instructions for use: Mix well before using. This product is made ready to use. If thinning is necessary use small amounts of water. It can be applied by either spraying or brushing (with a foam brush). Two coats are recommended for protection. Sanding is recommended between coats.

Typical dry times are 2-3 hours, but full-cure can take up to a week to harden from a soft coating.

No special requirements for storage or handling.

Forms and Sizes

Available in gloss (I-175) or satin (I-175-50)

Resources and Citations

Retrieved from "http://cameo.mfa.org/index.php?title=Camger_1-175_Polyglase_Environmental_Coating&oldid=83131"