Camger 1-175 Polyglase Environmental Coating

Description

Camger Coating Systems Inc. http://www.camger.com/coatings.htm

Poly Preserve Aliphatic Urethane Barrier poly(propylene glycol) Camger was making two different formulations: Polyglase 1-175 and 1-146. 1-175 was the formulation that was originally developed and tested for conservation use, but 1-146 was very similar in formulation and cost. For a period the company kept 1-146 but discontinued the 1-175, then later restarted production of 1-175.

1-175 has shown excellent adhesion properties to a wide variety of substrates such as, solid woods, particleboard, medite II. 1-175 when applied properly will provide adequate protection against contaminants.

Applications

• Coating - Clear Gloss Waterborne Finish
• Sealant for wood products used in interior of exhibition cases
• Gluing seams and as edge sealant for case materials (Field Museum)

Personal Risks

Not classified as hazardous under OSHA Haz-Com Standard (29 CFR 1910.1200), GHS

SDS obtained by contacting the company (no web link available)

Environmental Risks

Environmental precautions: No special measures required. Smaller quantities can be disposed of with household waste.

Physical and Chemical Properties

pH-value at 25 °C (77 °F): 7 - 8 Melting point/Melting range: Undetermined. Boiling point/Boiling range: 100 °C (212 °F) Flash point: >201 °C (>393.8 °F) Vapor pressure at 20 °C (68 °F): 23 hPa (17.3 mm Hg) Density at 20 °C (68 °F): 1.026 g/cm³ (8.56197 lbs/gal) Solubility in / Miscibility with Water: Not miscible or difficult to mix. VOC content: 1.6 g/l / 0.01 lb/gl

Working Properties

Instructions for use: Mix well before using. This product is made ready to use. If thinning is necessary use small amounts of water.

Can take up to a week to fully cure and harden from a soft coating (upon application).

No special requirements for storage or handling. ==Forms and Sizes

Resources and Citations

• Camger: Product Sheet